So my Kelly controller has a cruise control function. But I've noticed a glitch that causes the bike to over accelerate after the cruise control is deactivated and throttle is applied again. This is potentially dangerous. I need to apply throttle on and off slowly to get the speed functioning...
Could I attach a circuit or resistor like before (on the controller side) to make the motor sensor compatible. I'd rather not butcher the motor internals to change out the Mac thermistor.
Hi All,
Just realised that my temp sensor readout on the controller says 16 degrees C while using a 1000 ohm resistor the actual temperature is around 28C what is the actual resistance needed to get an accurate readout on this controller?
Im using a MAC 8t motor and y controller is the Kelly...
Recently had to replace my hall sensors. Putting my mac 8t motor back together but there was no O-ring. Just grease. Feel like putting grease back might not be my best option. might let dirt inside the gears? should I try to seal with silicone? or what type of grease do I need to use to create...