Recent content by frenchkiss

thanks youv very much, that help me a lot, and well done for this! you wrote all alone? is really clear and good detailled :)

thanks, i try but that doesnt change anything my throttle have a 0.90v min and 4.20v max i put setting for throttle in since 0.92v / 1.00v / 1.10v min and that doesnt change latency i tried to change the C rate v/sec and put 1v 2v 3v and 8v that doesnt change too what should be my setting...

thanks you very much :) this text can be found in french?

i understand what is going one, when i accelerate to 0%-10% wheel dont moove, its a dead line voltage for sure, the CA i see 0.91v 0% throttle and i put 0.90v-3.65v min and max imput, then i program it to 0.90v throttle in and that doesnt change

yes maybe, you means the problem can be the throttle instead of the setting? (the bar of % on display moove properly when i put gaz, in real time, so i thinks is a dead line voltage) did you know how reset setting ? thanks

yes i know but i didnt have this tools i have already break one connector before when i try :lol: and like i said the throttle didnt work anyway when i tried with last controller direct plug in can i, yes or no help my latency problem with CA programing only? :')

i have already did it with an other controller for check, and that dosnt work (the wheel dont turn) with my new controller i didnt have same connector for the throttle, so i cant try it without cut the wire i prefer try with the CA if you can say me what i have to do, thanks you! :)

any chance to change that with CA programming ?

thanks for replie i did it and the CA show % of throttle when i "put gaz" but the wheel didnt moove

hello, i have a problem with my build i have a 72v panasonic battery with 40a on 4110 12fet controller, i have a CA v3 too (crystalyte crown motor) my throttle have a latency of 1s - 1.5s and its really difficult to use it on the CA i see 0.91v 0% throttle and i put 0.90v-3.65v min and max...

thanks all for replies, nice bike robo4! :) - 730mm its the same size of a DNM fork - i will use this front brake with motorbike handlebar too for not did custom work - the weight isnt a problems - this fork and brake are used for 8-13hp motorbikes, i thinks its good quality for 5-10kw ebikes...

any chance to fit this fork on vector/qulbix frame? thanks :) https://www.minimx.fr/fr/fourche-dirt-bike/494-fourche-alu-730mm-inversee-dirt-bike.html#/produit_additionnel-kit_de_frein_simple_piston_axe_te_pontet_protection

2000 dollars included bms? was a nice deal :)

woow! that a nice battery! how much cost it?