Recent content by garyhgaryh

I’m thinking if hooking up a 72v battery on my 60v scooter. I am about to open up my scooter to verify I have capacitors in the controller that can handle 100v. I have one of those Nanrobot rs-7 scooter clones and I’ve taken it to 55 mph gps verified. I want to get a little bit more speed out...

I'm looking to buy an 8000watt scooter with these hub motors. Does anyone know anything about these motors?

Very nice! I wished i had seen this. I bought a new 36v 1000w controller from amazon and a 500w motor from fast scooter. Could have saved some money as it us just a motor from an iZip rebadged.

Thanks for your reply!

I’m upgrading my scooter in pieces one at a time. I want to upgrade the controller first and step up to a 1000w. I figure it should be ok for the motor. But what if I step up the voltage (from 24 to 36) and wattage (1000w). It will be hard on the motor but I should be ok right? Thanks, Gary

I just picked up a pristine Razor e300 (version 41). It was owned by a woman who rarely rode it and looks brand new. I'm not going to go all out. I'm going to overvolt this with two ryobi 18v 9ah batteries at 36volt connected in series. I also will be buying the 36 overvolt kit from fast...

No, only 1 led lit up. I need to find my original charger.. I know it's bad, just haven't had time to charge it. BTW, I did try to find old threads talking about this as I have seen it before, but I admit I didn't try to hard. Gary

I just moved and lost my charger for my ping battery. Today I decided to take my ezip 24 volt battery charger that I use to charge my ezip TrailZ and my e750 scooter and use it to charge my ping 24V LifePo4 Battery. The connector fit and it seems to charge without a problem. I haven't charged...

I bought my ezip 750 about a week ago and love it. It will complement my ezip Trailz bikes that I have for my wife and myself. Even uses the same charger. I also bought a 1000 watt scotter from east coast scooters. I will compare the two and if the 1000 watt one is indeed better, I will...

Yes, I would love to see pics. I hooked up the escape pod today. Took some pics and will post it soon. It's a nice unit, but after I installed it, it's slightly warped since the way I installed it was probably non conventional. I'd like to see (or hear) how you look up the escape pod...

Why do you want to change the XLR plug to anderson's? Trying to understand the reasoning. I bought anderson's because i need to connect the battery to the bike. I just picked up my escape hatch today. Here are some pics I just took.

thanks dogman. The wires on the currie electrical spring block is only 14 or 16 guage. I think I'll go to home depot or lowes to pick up a few feet of wires which should cost me less than 3-4 bucks rather than buying an entire roll for $10. Gary

Quick question: What gauge is the wire largest black and red wiring coming from the battery? I need to buy some wires and want to match up the gauge of the wire. Any cheap place to buy wires? I think walmart has a roll of heavy gauge wires for about $5 spool in their auto section. So it'll be...

I'm looking what consist of a "set". What is the "roll pin" for? Thanks, Gary

If I had not ordered, I would have gone this route. Those are damn good prices. Well, since anderson connectors are proven, I'm happy I paid $3/connector w/ pins rather than $9 w/pins at Graingers. There is no way I'm gonna pay $20 to get two wires to connect. That's just silly or I'm just...