Recent content by Gege2000

Congratulations!!! I think that your board is too small for a beginner. For a beginner, I think the volume and the width of the board must be enough to stand up on the water. It's important, because you must transfer the weight when the speed increase, and it's not possible if you're not on your...

And virus too! :D :D :D Q26Jb5H0_Jg

Pacificmeister is back! :D :D :D tTHMK67kJB4

I cut off the top of the index finger - and a bit the tendon - with a sanding disc, and I had allergy problems after the operation. :cry:

Hello, For the french and european people : because of a finger injury, I'm selling my efoil parts : https://www.leboncoin.fr/sports_hobbies/1315038051.htm Best regards.

Yes, according to my calculations, 5500W is enough (with a good propeller/rpm and board/foil).

Hi waterfox, My vision of your problems, if it can give you some help. I think it's multi-causes 1 Size of the board : for me it's important to use a board where you can stand up, the slingshot wakefoil has a too low volume. 2 Position of your body : you must be able to maintain le board flat on...

My SSS56104-kv500 has a 8mm shaft.

In my Neugart PLE40/i=8, there is a ring that can be removed.

Wohoho! Congrats! :D It looks a very clean build. Would you send some detail pictures? Best regards.

All these foils on page 23 here : https://issuu.com/slingshotsports/docs/2018-windsurf-foil-collection-book-

Alibaba with Visa credit card (so with the payment protection (12$ fees)).

I ordered the n°4, because it's the NF2 Wakefoil of Slingshot, so you can find a lot of videos with it, and I ordered differents sizes of mast to test the foil at the wakepark. I think that the ratio (front wing surface) / (rear wing surface) of the n°1 is too high. Bytheway, this seller sells...

Saw it, but no hollow mast. Not easy to drill straight on such length. Or must add a 3D printed piece around the mast for the wires.

Thanks for these informations.