Recent content by h27

Thank you rivers. They seem to have a double chainring solution for Bafang but for the TSDZ2 there are only the 42T and 40T chainrings.

Thank you Elinx. I had hoped for a simple solution and to avoid soldering this time...

After 10'500 km of happily riding my TSDZ2/OSF someone ran over my bike and I need some help for the rebuild: 1) Can anyone help with a source for the APT bootloader other than EcoCycles (website down, no e-mail replies) or Electrify Bike (do not ship outside of USA)? 2) I would like to have a...

Thank you very much, perryscope, for the explanations and the code. This will be very helpful, when I try to build my turn signal/blinker and brake lights (I think I will go with the simpler hardwired version). Your bike-train is a very nice project and build! :thumb:

Nice job, perryscope! I would be very interested in your code and some more details of your build. I‘m not sure if I understood everything you wrote: Did you do an Arduino controlled version and a TSDZ2 controlled version? Where did you plug it in? Battery? TSDZ2 cable? Separate battery?

External signal would be fine and Arduino would be nice as you could have control over blink rate etc. What I had in mind was a more fool proof solution such as an adaption of some existing system for motor bikes (combustion/scooters). There are many of these on the market, some need a relay...

Has anybody been experimenting with turn signals/blinkers? I would like to add some to my tsdz2 because I am often riding at night on steep roads with lots of traffic and I don‘t like to let go the handlebar in this situation to signal a turn. I think adding electric turn signals would be a bit...

Thanks to casainho my issues with the white screen and the inverted screen on the 850C were solved with version 4.2. and I could finally ride my bike. Wonderful experience already with OSF version 19.0 - thanks to everybody contributing! Last weekend I added the temperature sensor and improved...

Thanks for version 0.4.2., casainho. Works perfectly. The immediade reset after a change of the setting is a very nice extra!

Thanks again for you work. Is this the bootloader version? And if not: Would you be kind enough to also produce the bootloader version (or tell me how to do it)? By the way: Last weekend I finally could take my first ride on the new bike with versions 0.4.1 and 0.19.0. It was a great experience...

Great, thanks.

I tested the firmware: I could change the display setting to invert but it didn‘t change the screen. I also tried to turn off/restart the screen, but the invert setting is not being saved (after restart the setting is back to default). In general I think you are right with option 3. There will...

Thanks a lot again! I will install, try and report this evening.

The issue with the white screen is resolved indeed. But I am a bit desparate: The information shown on the display is now mirrored. Help appreciated!

I seem to have a very wicked display... I could install the new version and it resolved the white screen issue (thanks to all the developers!). But the result was a mirrored screen. Any solutions or ideas what I could do?