Recent content by hass

I wish I did. But If I find a solution I will update the thread.

The spst relay from the link above didn't work unfortunately. Same issue its cutting the ebrake but not energising the relay to light the lights up.

I don't have to grounds I don't think. One end coming out of my controller is 5v and the other end is ground 0v From my understanding is the 5v become 0v when brake lever is applied. I'm not sure what the issue is to diagnose. I'm not technical when it comes down to electronics. Reason for...

I've ordered the relay from the link above. I'm wondering if the relay i ordered originally is wrong. Maybe something to do with the voltages.

When using the opto relay

Here is the spec on the relay

Hi I've tried the relays that I posted up and still no good. It shuts off the ebrake but don't light up the leds. Its not locking the relay (no click) Could it be wrong relays again?

Ignore this I've just realised what a spst relay does

also as I'm not technical Could you do a wiring diagram on what wire goes where. Or just pin numbers if you can

Hi great Would this work?

I'm really not sure I found on this site how to wire brake lights with e brake

Hi This is nit my diagram I dont know how to do my own one. I've used this off of this site Its exactly the same as my set up. The blue wire is the 5v which comes out of the controller for the motor cut off

I'm hoping its just the relays that is my issues

I've also just ordered this relay which is coming from china

I've got these relays Ones 103 resistor 12v And ones 222 resistor 5v