Recent content by Henro

I had similar issues installing the temperature sensor. My kit is from Electrify Bike Co, and has a bafang wiring harness, which uses different colors. For me it turned out that blue was throttle and red was +5V. Black is still ground. Inspect where your wires go very carefully. More info on...

Wish that information had been obvious two days ago. Hope this helps the next person out. I attached the temp sensor to the blue and red wires (blue is throttle, red is 5v, black is still gnd) and it worked as expected. Still having the same problem where it boots at battery connect, and...

That's what I thought as well (and it looks like that's the case) but the weird part is that when I tested the plug going out of the controller, all of the colors and pins match as per this photo: Here's a photo of my controller. It looks to me as though blue and red are throttle and 5v...

Hi everyone, I'm in the middle of setting up the Electrify Bike Kit with prewired connectors, and while I had no problems installing the firmware, I'm having some issues with the temperature sensor installation. I believe this is the 8 wire version, since it came with a throttle and I counted 8...