Recent content by jakoeira

Yes! It worked for me no errors now. Thanks! :D Trying to configure battery I realized fault was triggered by using a rated motor current value too small. I set it at 35A now.

Thanks for the response. When I click Reset Status, and push read button from display only frame, error persists. :( This data comes from other people at this forum and whirlpool BH bikes thread. It's a signal from the internal speed sensor. We have been trying to hack limitation and played...

What parameters are related to current scaling? Also noticed that speed signal form controller has 6 pulses per revoltion. Does it mean motor has 6 poles? Should I use 6/gear ratio to fill magnets field? I found in this forum this Dapu specs: 7.9 RPM/V 260rpm nominal Cheers

Hi, First message sent to this forum, but I have been reading it for years. Great community! I have tried to config the controller but can't start motor discovery phase. Could it be related to the controller fault state? Faulting bit 1 is related to current scaling. Also have bit 7 activated...