I've had problem after re-assembling my ebike. No action from the throttle, looked inside the controller the LED was flashing 6 times. Its a SUNWIN 1500W Controller.
I've found info that tells me 6 flashes is a problem with one of the phases. I tested the phases, one of them had a short to...
Hi,
I've had problem after re-assembling my ebike. No action from the throttle, looked inside the controller the LED was flashing 6 times.
I've found info that tells me 6 flashes is a problem with one of the phases. I tested the phases, one of them had a short to ground. So there were 3 FETs...
Does anyone have an error code list for this controller?
I have just re-assembled my bike and it's not working. The motor spun for a second and then nothing.
Looking inside the controller, the LED is blinking 6 times in a repetitive loop.
I've only changed the battery from 13s to 14s. I...
Maybe I should have changed the title. The charger I have is from the website called "BMS Battery". So this post is nothing to do with the BMS as such.
I want to adjust the charge voltage output for 14s. I can only get it up to 56V. The trim pot has then reached its limit. Is there anyway I can...
Hi,
I have a new battery and want to use my old charger from BMS battery. My new battery is 14s, to requires a voltage of 58.8V.
I previously had a 12s setup. I found out that the voltage on these charger can be adjusted via a trim pot, however my charger maxes out at 56V.
Can I modify the...
Hi,
I have two mulitstar 6s bricks connected in serial. I bulk charge in serial. I would like to add a BMS like the one in the link
How would I use my bulk charger with two of these BMS? Could I just plug each of the balance leads from each battery into each of the BMSs and connect the bulk...
Hi all,
I'm trying to solder xt90 connectors to some turnigy lipos. I've take the 5.5 bullet connector off. However the solder doesn't seem to take to the wire from the battery.
Could you tell me which type of solder I need?
thanks
With regards the the 3 speed switch. How does this work??
Are the lower speeds the same as using the throttle to control the speed?
Basically I don't want a 3 speed switch and would have it default to the fastest speed. So if I use less throttle would it be the same as using a lower speed...