Recent content by jdash

I'd better give up! Thanks for all the advice!

I found that there are cheap angle grinders. Cheap ones will work fine on (aluminum) bike frames? Maybe I can buy one. But, still, I wonder whether it is ok to grind off some part bottom backet for Bafang installation.

Then, it's highly likely that grinding away some portion of bottom bracket will be needed (using an angle grinder?). Is it ok to do that? Threads inside bottom bracket go deep enough so that shaving off doesn't cause any problem? Modifying the frame sounds difficult for me. Where can I ask such...

If the belt lining can be done just by adding some sort of spacers, it may be easier. But is is possible whether it would be required to shave off the bottom bracket?

Thanks for the reply. Is it easy to measure the exact size of chainline? How much does it cost roughly to make a custom adapter at a CNC shop? Any recommended CNC shop?

Hi, I'm seriously considering to buy a Priority Eight (http://www.prioritybicycles.com/theeight) and install BBS02/BBSHD to it. But this is a fairly new bike, and I cannot find any information whether it is feasible or not. The potential problem may occur from its belt drive. I don't want to...

What would be good bikes for Bafang (or eRad) 750W conversion that have belt drive and internal gear hub? I looked around but it was hard to find right ones or to tell whether they are compatible with Bafang or not. I like the belt drive because it is really clean. For IGH, I prefer NuVinci, but...