OK- I replaced 2 hall sensors and the clutch, it is all working as expected. Also happy to report that soaking the motor (windings and all) in evaporust for 24 hours worked like a charm! Thank you everyone- this thing is fast!
Sure enough. I have 2 bad hull sensors. It's #3 and the speed sensor #4 that works off the button magnets on the case cover. For future reference this thing was rusty when I cracked it open. I soaked the entire assembly in evaporust. We will see if it works I tested phase wires for the same...
Thank you! I will there is something out of whack with that as the controller was getting real hot fast which is exactly what you are saying- I will double check that and should be on my way! I did plug in the self learn wires maybe there is only so much they can do- it was spinning in the...
I recently replaced a blown set of controllers on an Ariel Grizzly. I bought the no name linked controllers off amazon for $130 they seem to work fine. I did lose pedal assist. Another issue I am working around is that the front wheel seems to spin wildly faster than the rear so it's not worked...
I believe my clutch is stuck. I took apart the motor today and it only turns 1 way. I ordered a new one for $30 bucks or so. Working on cleaning the motor up while I wait for that part to come in. I noticed that Grin made a video of the welded clutch and was not sure I understood the concept of...
done, not sure what that does I had mine at 72- it seems slower- probably a good thing as I could have caused damage.
Now I just need to figure out why my front controller gets HOT fast. Something else that is interesting about it is that when I plugged in the learning wire it spins VERY fast...
Ok another update both motors are running on throttle!
I don't see anyway that this controller set has pedal assist also so I am on the look out for a set that does.
One last strange thing is that the front wheel does not turn backwards with power or no power it does not turn. It goes forward...
It spins on its own power in the learn mode.
I will check the options that I have for the display.
The motor does have a white wire coming out of it which I have plugged into the speed sensor of the controller (because all those wires are together the 3 hall wires , ground ,5v and the WH)...
Update! I have the rear motor hooked up and works in the learning mode. Shows speed on the controller. However when I unhook that the display states I need to have speed gauge magnetic steel number. If course I *think* that's number of motor magnets. Does anyone have that information for a...
Using two identical ones did not cross my mind. The current factory set up has a handle bar switch from rear, both, or front motor.
The motors are sensor motors I do not know enough about it. would need to have 2 displays to make them function. Seems like the displays control the controller...