Recent content by Jon dor

hope you don't mind me jumping in here I have the learning wires but no throttle I use only PAS on my bike, so when I plug the learning wires in my wheel does not spin but the motor makes a noise, when I unplug it and plug in again my rear wheel spins .am i doing something wrong or are my phase...

I have a 250w rear hub Bafang with the s830 display now in P07 its for magnet speed 1-255 the lower numbers give crazy speed readings but at 255 I am still 12km too fast compared to my GPS what am I doing wrong I have a Candance PAS sensor 12 magnets a dual controller 36/38v 15ah 48v 21a battery...

well thank you for this I would just like to add I have the Knaap AMS boy fat bike 20x4 inch wheels, as above I have changed the wheel settings about 4 times to get a more accurate speed reading on the display. I went to 24 the settings but that put my speed at 4 km/h over my GPS reading I then...

No I don't there illigal here in the Netherlands,I tried pas 0-9 well 123 I got no assist 4 gave me a 17km/pH 5 gave me 25km/pH and six gave me around 35km/pH that's why I'm thinking the percentage settings done at the factory are really off .

this is what I'm looking for that's why i thought with anew controller and display it would be possible I'm still sure it is but i will wait and see how 0-9 turns out later

Changed pas level now to 0-9 and sett speed to 100km/hr so I will see later today if this is the solution,I hope so because this bike so heavy in pas assist 1-2-3 in pas level 0-5 so let's see .

You see different

No it isn't and my pas setting on my display is p5 not p3 but thanks

I have tried a thousand time to do this but when I press enter it won't give the option to adjust any percentage.

Ok will do thanks for the feed back really appreciate it.ill give you an update after I leave the office today I'll set it 0-9 and will set the speed limit to 100km/hr

I have at this moment I have 0-3 1 gives me 19km 2 gives me 25km 3 gives 25km as for your suggestion pas 11 -1 pas12-5 I have already done that.and like I said in this display and controler it's not possible to change the pedal assist percentage.But that's what I've been searching for because...

YL81F display

Hi thanks for the speedy reply I have the password for the display but like I say when in the settings I can change pas level's.But not the percentage levels for each level.thats what I been trying to do,the only one I have seen up to now is on the G Force T42 folding fat tyre bike.

Ok this my battery and we know my bike has a 48v 250watt motor ,so is there and display controller out that that can install with the options to change pedal assist percentage in the settings.

Aha in my settings on my display NC-81F it is set to 40ah and that is default setting.