Recent content by JoshKeller

Does anyone happen to know what would cause an error code 10 on the sw900 display and brain power 1000w controller? It works fine with my s866 display. I also swapped a csc1000w controller that works fine with the sw900, but gets an error message of e10 with the s866. I'm guessing the units...

I did find oil residue coming from the piston on my caliper. Swapped it out (cheaper to swap out caliper than try to rebuild it) and it worked great all day today will checking cameras.

I ordered a 2 pack of tetkro pads. And 2 Shimano rotors. If it happens again, I'll put my mechanical brakes back on the front with my 2nd set of pads and rotor.

These are the pads and rotors I got. https://www.amazon.com/dp/B097R497TP/ref=cm_sw_r_cp_apa_glt_fabc_Z8X8A4P45NHC9CT62KJY?_encoding=UTF8&psc=1 https://www.amazon.com/dp/B083JG1S1V/ref=cm_sw_r_cp_apa_glt_fabc_BHKSKCBTRYDNS5HNKPA1?_encoding=UTF8&psc=1 Any suggestions on brands? And as for...

I have a Chinese ebike that I use for hunting. I've upgraded to hydraulic brakes. The back works great. The front not so much. The pads and rotor last about 5 miles until they no longer stop and start squealing badly. Granted this is cheap amazon rotors and pads. I'm setting the calipers by...

I ordered the kt controller. I will update when it arrives. I messed with all the p settings and I found 014 is current limiting - changing that from 20 to 2 had no effect at all on current draw. Perhaps just a junk controller or a communication fault with the lcd?

Some more info. This is the bms I have. It's 30a discharge, 15a charge, so I don't think it's the bms since it is the same with both batteries.

Hey guys, I was referred here by a Facebook group. I have a Chinese "1000"w geared hub ebike that originally came with a 17a controller. I've replaced the controller with a 37a max and s866 screen to 22 amps and it did provide more power. I still can only get 13a max from it. I've tried two...