Recent content by jumpjack

  1. jumpjack

    Thread for new battery breakthrough PR releases

    What about these new amazing cells from Tesla? They named them 4860.... erroneously, because it should have been 48600 (*), but what about their tech spec? I read "5x energy density" but also "+15% range", so what's wrong here? Which are real specs?!? (*) Lithium battery correct cylindrical...
  2. jumpjack

    Patented (?) method to determine right controller/BLDC wiring

    I can't understand how a person can think of patenting a method... anyway this guy (Jerry Leitz) did it: he patented a method to determine how to connect hall and phase wires between controller and motor... METHOD FOR DETERMINING CORRECT PHASING OF A THREE-PHASE BRUSHLESS DC MOTOR But please...
  3. jumpjack

    Charge 52V Dolphin with this MPT-7210A?

    Is there any tutorial/manual for this regulator? I read it is also for lithium, but cant find any screenshot showing charge curve or battery type.
  4. jumpjack

    Fuse Questions

    To know exact behaviour, currents and timings of a fuse, you have to study the curves in its datasheet. Fuses don't just "break", it's a matter of time and energy.
  5. jumpjack

    Thread for new battery breakthrough PR releases

    New, longlife NCM battery (NCM532/AG) , thanks to new type of electrolyte and "artificial graphite (AG)": up to 5000 cycles at 1C and DoD100%, 1 year storage time without self-discharge: http://jes.ecsdl.org/content/166/13/A3031.full
  6. jumpjack

    Kelly Controllers Configuration Program - a Definitive Translation

    Did anybody figure out what this slider actually means? Could it be the width of the "joystick dead zone"?
  7. jumpjack

    Sinusoidal wave brushless motor controller

    I also tried decoding the error codes, I obtained this picture: This BASIC source decodes the raw data into human readable error messages (if above picture is right): Sub conv(Data9Data10) Dim ErrorText(15) Dim ErrorNum(15) ​ ErrorText(0) = "n/a 1" ErrorText(1) = "Trac­tion battery over...
  8. jumpjack

    Sinusoidal wave brushless motor controller

    using documentation available around and documwntation from Kelly, I was able to build this table: It summarizes all serial commands I am aware of. I didn't start experimenting yet, anyway I'm going to do that using an ESP32 module rather than an arduino, as it has builtin wifi, bluetooth and...
  9. jumpjack

    Kelly, CANBUS and Arduino

    Found something about Kelly usage of CANBUS protocol: http://www.oblibene.biz/userdata/shopimg/elektrolode/file/KBL%20User%20Manual.pdf Table 2: KBL Controller CAN Commands List (page 15) Any suggestion about USB/CANBUS module which could be used both on PC and on Arduino? I also received...
  10. jumpjack

    Connection diagram of an advanced BMS in an EV

    They were recently published two interesting documents describing in detail the connections of an "advanced" BMS inside an EV. "Advanced" because it does not just manage the cells, but the whole vehicle, thanks to several contactors and sensors. The BMS comes in two variants: modular (BMS-M12...
  11. jumpjack

    Random power cut issues

    How can I usae CANBUS to read data from a kelly controller?
  12. jumpjack

    Power cut issues with Kelly KHB72701

    The power arriving to my motor is sometimes cut down from nominal 5 kW to 4 kW, then 3kW, and eventually to 0.8 kW (10A at 80V). BUT Battery is full (80V for a 72V nominal battery). Cells are fine (lowest is at 3.3V, highest is 3.34V) Temperature can vary from 15°C to 35°C when problem arises...
  13. jumpjack

    Random power cut issues

    I am encountering some issues on my electric car since some months, and nobody here appears to be able to figure out what is going on, even the shop which sold it to me; they totally replaced the BMS and the service battery, thinking that they could in some way affect the electrical system of...
  14. jumpjack

    Highest capacity 18650 cells

    I am talking of raw numbers, not charts.
  15. jumpjack

    Highest capacity 18650 cells

    If database on https://lygte-info.dk/ was public it would be possible to create a sparse chart showing various LVC values. Is there a method to access raw data?
Back
Top