Recent content by kaliandg

Tried to use main branch with the LCD, and delays with the brakes are gone.

Newly soldered FOC sensor works great. I did not explain the issue correctly in my previous post – when I apply the brakes wheel try to continue spinning up until current drops to 0 (magenta current scale above speed scale on Bluosec application). Same happens with the LCD. Not sure if this is...

Thank you Stancecoke for your answer, Yes i used the main branch. I've just soldered in ACS758LCB-100B FOC sensor, will re-adjust settings and try to use the branch, Regards,

Hi, may be somebody more knowledgeable can help me out with my issue: I have S06 18FET controller, direct drive motor 1.5Kw, throttle, PAS sensor, hall sensors in the wheel. No torque or FOC sensors. Opensource firmware works great, except for one thing – sometimes, when I’m trying to stop...