Recent content by kFox

We did a power test today with this 3000W mid-drive QS and the standard Votol controller. For those curious, set a: Bushbar max 120A Phase current at 9960 Voltage 72 Speed percentages all at 100% All parts standard 12 inch wheel We got max of 81km/h And 8,6kw

On that subject, can you? Because I can’t drive the motor when I’m conntected and I’m going to test the motor during a power test. It’s nice to see the display page on the PC while using the motor. This display page does show live rpm but only if I manually turn the wheel, can’t use throttle.

Not sure why anyone would make a double account, maybe to get the idea out it’s very important or maybe they are two separate people in a big building with shared internet, maybe a school? Just wanted to let you know that I value your replies a lot guys. Because of the info in this thread I got...

Thanks for the info. If I read it correctly then I am on the right way. To get to a steady 47km/h with low power consumption as possible I can change: To get right speed: 1. % in three speed settings To get power consumtion as low as possible, which will cost acceleration 1. busbar current 2...

Thanks Larsb for the referral. Hello guys, As mentioned before I have the QS 3000W motor with the Votol 150 controller and I’m trying to get the right settings. It’s build in a little car with weight of 280kg without 2 passengers so max weight is 430kg including passengers and battery. I’m...

Hello guys, I have this exact motor with the Votol 150 controller and I’m trying to get the right settings. It’s build in a little car with weight of 280kg without 2 passengers so max weight is 430kg including passengers and battery. I’m going for a max speed of 47km/h. Long range is...

Thanks Larsb. Being the impatient guy I am I went ahead with my proposal just before you replied. That means rx controller —> rx usb And this works. Maybe green on the USB isn’t TX but RX?... As it is working I assume it’s ok. Or maybe it works no matter how connected? Also... feel stupid I...

Hi everyone. I’ve got a QS motor with the same controller installed and working fine. These posts of you guys was very helpful in setting things up. I would like to get into the controller to limit it’s speed and acceleration. I’ve bought a pl2303 cable and also have a controller with only 3...