Recent content by larghio

I completely agree. But they are way to bulky. I have three haillong packs and spare cases for when they crack and split open. And they do Sent from my Nexus 6 using Tapatalk

There is a new hailong case with room for 65 cells. It has a switch and usb output. Finally, I will be able to switch off the bms for winter storage :D...

my green dk-11 from ebay are momentary. not latching

When ever i change my pas assist level with auxd switches the motor drops out for what feels like 1-2 second. This was not the case with auxA on b3 kind of annoying when I need to increase assist for a hill and loose alot of momentum. Is this normal ?

Mine is mounted on my commuter and working great :)

Looking forward to trying it. Bought dual wuxing buttons, they seem like a good fit for auxd mod http://m.ebay.com/itm/272009885557 Sent from my Nexus 6 using Tapatalk

Greetings from Norway. I have the same problem. I tried changing my fuse from c type to d type. Works ok on lower settings. When higher settings Are required i just change the fuse to a 20A. Semi Unsafe and illegal. Will upgrade wiring when funds allow. We have 380v ie 3 phase 230v. It's called...

I am looking forward to see the hairdrier array in action :)

I like mine :) http://www.loudbicycle.com/

Does anyone know what the "update capacity" does in the statistics menu on newer firmwares?

In health monitor U:, hall voltage and mosfet temp fluctuate alot. in charge menu pack voltage and supply voltage fluctuate. even when no supply is connected. (or the coil) this has to be the reason for the constant charge loop at end of charge. how are yours? do they move at all? mine float...

Yes. I figured that could be normal behavior. But it is the same when i disable bms. Is it normal to have the pack voltage fluctuate on the display when pack i sitting idle. ie not charging riding or balancing?

If you mean supply vdrop. Then yes. I set it to 7v just to be sure. After updating to the newest firmware, the balancing does not turn off. great feature, but it has been balancing all night and the pack is now 0.013v out of balance. it was 0.08v when i left it. end charge voltage was set to...

Small update I set the maximum cell voltage to 4.1v and the charge voltage to 74.1v (4.11v) when it cycled between detecting charger and charge current to low I figured that is wrong, so i upped the maximum cell voltage to 4.15. the bms probably ended the charging when it hit max cell volt It...

I have a eltek flatpack on the way, but do you really think that is the problem. It works just fine in the CC phase, its when its running low current at the end of the charge the problem occurs.