Hello everyone,
Do you happen to know if there are online shops that sell a Reention Kirin 6-pin Discharge Port separately?
Thank you for the heads up.
Yes sir. All the connections. Unplugged, cleaned and plugged again.
Even if the connections for the throttle and PAS sensor are disconnected, the motor still spins slightly.
UPDATE: Solved! It was a Controller issue. Bought a new one and all is well. Thanks for all the input.
After 6000+km of daily commuting, I found an issue with my bike. Even on idle, the motor slightly spins.
https://youtu.be/rnWNs1U8HPo
It sounds like rubber, don't you think?
My guess that it's the rubber seal. I've read some hubs have those to protect from water and dirt. Maybe I was cleaning too meticulously that I rub off the lubrication down there?
I need some help.
Geared Hub Motor
- squeaky sound
- a noticeable drag
I notice this after cleaning my bike during the weekend.
It's not the brakes.
I did a separate test by removing the brakes.
What could it be?
Thanks.
Video:
https://www.facebook.com/568996782/videos/10157470570496783/