Recent content by Masure

Looks like pla

Hi, I'd like to add low ESR capcitors as suggested in several topics. My setup is 6S battery with Turnigy DLUX 100A controler. I'd like to use these caps : 35V 2200uF 14mOhm http://www.digikey.fr/product-detail/fr/EEU-FR1V222/P14451-ND/2433585 Is it a good choice ? How many of them do I need...

What kind of thing did you tailored ? I'm using your piece of code nearl as is and don't know what king of improvement could be made. Thinking of antislip/wheel speed sync for my friction drive but don't know how to start. I think a "speed follower" control would be great for my usage.

Ok i'm clearly below this point. i'm gonna modify my design to get beyond. Thanks for your advice !

Hi, I finally made my mounting bracket and did the first test with my friction drive. It's not bad for a first try but I have an issue. The motor disengages itself once the maximum speed is reached. I don't know whether the geometry or the "spring" is the cause. The spring is just an elastic...

Thanks for your advice, I managed to get a servo tester but it was a not better. Then I found the issu => too weak voltage with the power supply I used (15v) :oops:. Using my 6S battery did the trick. I'm now working on the bike mount design. I also have to perfectly understand the code. I...

I found the cause and I feel like the noob I am :?. The 15v power supply I used was too weak to start the motor correctly. I tested with my 6S battery and it's starting flawlessly.

I'm on making a friction drive based on : - Turnigy SK3 6364 - Turnigy Dlux 100A - Arduino and Gwhy and folken's codeto drive the controler. The motor is stuttering when i'm sending the PWM signal to the controler. If I gently retain the motor, it starts spinning normaly. SPM6TMCDjm8 Dlux...

Hi folks, I'd some help here. I plugged the motor in and it does not start by itself. It's stuttering and can start if I retain a little the can. No idea what to check. https://www.youtube.com/watch?v=SPM6TMCDjm8

Hi Folken, I did some work on your circuit and here is what I have : Soldered all the I2C interface pins to the screen in a compact block. Not so easy ! Soldered all the arduino circuit. Not easier ! The small DC DC switching convertor fits very well in the box. I recommend it. I...

Hi there, As I said, I want to replicate folken's work. Even if I understand the whole picture, I'd like a quick validation of the wiring before I go further. Notes : - 3 phase motor and dlux controller are not accurately drawn. I just put a DC motor and no controller on the diagram. I...

I ordered this regulator. I'm a bit worry to have more connections to the battery leads because I must be very clean with my assembly to prevent any shorts :). Did you make any insulation around the hall connections ? I have to buy some capacitors but no idea which values to take. I will...

Thanks for your advices. I would have directly used the 5v from DLUX ESC :). So if I try to sum up the components I have to use . Resistors : - pull down resistor from A3 input to GND - 2 resistors to make voltage divider to read Batt+ on A2 input. Capacitors : - between A2 and GND to read...

@Folken I'd like to build a friction drive with the very same electronic parts you used : arduino, hall sensor for current control, ... I have very basic electronics knowledge and I'm not able to design your circuit like you did. Looking at your pictures (the one with the box opened and your...

Thanks for sharing ! How do you balance the motor weight ? Do you use any kind of spring ? I noticed this on other friction drives.