Recent content by michih.

Yes, I've had that error a few times. e01 motor init MFG Michael

OK, I see. the quality is not good. For the price I expect a fully functional device. i will send it back MFG Michael

is there a solution to the condensation problem? and why does my charger just delete the coustum profiles. the device is new. costs a lot of coal. unfortunately the quality is bad. MFG Michael

no power, then burnt mosfets. maybe a problem with the engine? or something is difficult? MFG Michael

when do you want to release the v20.1C.4? MFG Michael

does the software also work for the p860c display? is this a new version? there is an 860c and a p860c at Ali ...... MFG Michael

does the software also work for the p860c display? is this a new version? there is an 860c and a p860c at Ali ...... MFG Michael

yes right, the v2 original is quieter! a drivability like the mspider version paired with the advantages of the v2 would be great! would always be better. but i think it is limited by the internal torque sensor. i have a rocky mountain powerplay. that's a different system. in my eyes, the bike...

This meant less consumption than with the V1. the mspider65 version is super responsive. the motor does not revolve and reacts fairly well to changes in force. drives better than the current bosch gen4. the paired with the v2 controller (less consumption and quieter) is a very high level !! mfg...

the motor is significantly quieter with the new controller! I can already say that. I tested the controller with the tft500 in one of my old motors. the unpleasant higher frequencies are gone. A lower consumption and therefore less heat generation and the performance of the mspider65 version...

Is activated.... MFG Michael

have 2 here. am from Germany MFG Michael

have tested the c3 times. at cadence over 60 there is hardly any power left. MFG Michael

ok, if you want you can send it to me for testing. MFG Michael

do you also have an update to test for the vlcd6? MFG Michael