Recent content by Mike-P

Thanks

Reading the Wiki whilst mine is disassembled I thought I ought to check the PAS sensor but the controller unit seems to stuck in place solid. Is there a trick to releasing it?

Received my new torques sensor and the cabled part is of a different design Original As supplied (albeit without the springs - have raised the matter) Note only two springs are shown in the suppliers photo and the wire connection is through a deep plastic moulding. I'm assuming if it now is...

Thanks for the advice. One solution is to wrap some rubber (bits of old inner tube) around the frame at the appropriate location which aside from stopping the bracket/clamp biting into the frame also stops any creaking noises arising there. I do have a problem with those parts in that the...

Found a youtube video https://www.youtube.com/watch?v=-V3G0GSx4zg taking a completely different approach knocking the lot out from the rear which worked albeit probably potentially not too good for the health of the torque sensor. The only thing that seems looks faulty/seems odd is that only two...

Thanks - easing does not seem to be working :(

Stripping mine down to try to establish what the fault might me and I cannot get anything to budge having taken the circlips off Any suggestions would be appreciated. The o ring meanwhile has fallen off - presume it needs a new one, what size should I order?

Got it into maintenance mode but instead of any torque sensor readout it showed beneath the large r e the total mileage covered and the motor did work briefly. Restarted and now in maintenance mode four zeros (still with miles thereafter) and which never changed. Wondering if I have both a...

Thanks for the info re the maintenance section :thumb: Its not the magnet - speed display is working fine on the display currently. The SW102 did arrive but not the necessary cable :( Think I'll leave it till the weekend to investigate further.

Tried that but some reason it jumps back to the main display before reaching it. Have just been out on the bike and the motor occasionally kicked in. I have had problems with the VLCD5 with it not showing speed or battery level at times and wondering whether its a fault with that - have a SW102...

My TSDZ2 suddenly stopped assisting today - display okay working lights correctly but no assistance from the motor. Do I take it needs a new torque sensor or could it be something else?

Oh! I was reading the technical specification document on it which refers to a "Micro USB serial communication port, convenient for maintenance purposes. Still awaiting delivery of mine.

Anyone know if the SW102 display gives power out on the micro usb port - have a 6v directional indicator remote on the handlebars that uses a pair of CR2025s and wondering if I could wire it to the port instead.

My VLCD5 display played up today giving a speed of 0.0mph and an indication of :lowbatt: ; towards end of this mornings commute it did come to life. Back home this evening after powering it off and on a few times did started show accurate reading. It has been very cold recently and last night...

Surely that has too many teeth = the TSDZ2 wrench only has 8 teeth