Recent content by MikeLemon

Hi came from the future. Where can I buy such a device that can handle atleast 10A continues 52V? I'd like to use it to isolate the charging port for the battery when a charger is not connected and over all prevent reverse oltage if an incompatible charger gets connected. Thanks.

Also looking for a reliable automotive grade circuit breaker that can handle 96V 400A

Hello, I'm looking to convert my 250cc VL daystar from Dealim: to electric with the constrains being up to 35kW and a system voltage of 24S liion(max 100V). Now I've never dealt with such power electronics(Other than electric skateboards with 12S 60A max systems) so I'm unfamiliar of...

Hello, I'm looking for a proper 3S BMS that follow this critiries price is not an issue: 3S Lipo 20A-30A charging current 4.2V cell cutt off 3.3V cell cutt off balancing I don't get all the BMS available out there whe is the high cut off voltage always so high and the low cutt off is always...

Yeah sorry about the latency was very busy and didn't notice the replay so: Battery voltage 32V-43ishV (10S3P) Current: 60A For the mosfet http://www.irf.com/product-info/datasheets/data/irf3205.pdf should work

Hello there I'm working on a similar project could you please share the code with us? Thanks in advance.

Hello, I've been looking everywhere and couldn't find the right BMS for multi lipo cells sins all have a too low discharge voltage too high of a charge voltage and mostly slow balance current(Bad for my big 3S 22AH battery which I want to charge with 30A) Now I'm less worried about the balance...

Hello, I'm tring to make an E-Switch for my E-board but the design will be universal and I came across a problem. I've started doing it after I found out that the BMS's switch gets stuck at the ON position every time!(I've bought the same BMS and after a while came across this issue over and...