Recent content by Minifreakmartin

I also observed the following: When voltage measured at solenoid it shows a 1-2v drop uphill but when measured on controller a massive drop to 30v-37v. I already changed the cable but to no avail. Voltage drop going uphill at battery direct is from 65v to 63.4v When level and in stands...

Thanks so much for the response. The one with the circuit board is defective and missing parts. If its a potentiometer throttle what are all the other electronics needed on the circuit board? Most other throttles just have a simple potentiometer and nothing else I currently have the hall...

The above is very helpful. I have a question about a throttle for my 60v massimo Utv. The old throttle to the left is what type? Hall or pot? The old on on the left has so many more conductors vs the replacement I found on the right. I have the issue that is has very little low end power when...

Thank you for all your replies. Ultimately changing the Hall Wires and setting the hall gift angle from 60 to 120 made it work very smooth going forward. Last issue. When in reverse the motor goes very slow and the cuts out? it shows its in reverse in the software

Hi Amberwolf I really appreciate your detailed response! The batteries are brand new! I unfortunately do not know the motor properties and have a hard time contacting the manufacturer. I just switched the hall wires all kinds of ways and it just makes the motor stutter in any other settings...

Hello Forum, I'm happy to have found this community as I'm struggling to get the Massimo Buck 60E UTV running. The original controller burned out, therefore I got the VOTOL EM 150. ( not sure if it was the right choice as the old controller looked much bigger) The UTV looses power after a...