Recent content by mittkonto

Or, you could utilize the 'cruise'-function and keep things kosher as it should be. *cough* :wink:

0.20, makes every ride an early christmas. Can't wait to see what sw102 and 850c when its a bit more mature around the curve! I have seen the awesome torque calibration work that has been done, though my torquesensor is not health personified, I'm holding off a bit. Thanks devs and testers again!!!

You devs are awesome!!!

Nice find BalorNG! Came here to post something I stumbled upon lurking and raking the net about odrive for a corexy machine. Anyho, found these type of Linear Actuators, which very well could be the droids we are looking for as they are conveniently packaged. Never mind the fancy remote &...

Hm, Ok. What is 'I_max' ?

So, using PAS mode it would be as if I put in a lot of wattage or how does that work? But the emtb is so nice!!!

Update: Managed to actually "tare off" one of the leads! The Right One™!!! 8) :lol: Resoldering, was a.. doozy. I could somehow though, lots of solder, not winning any neat solder of the year awards anytime soon. Digging in the silicone, as by a dried up well in the desert. However, the...

I have installed a temp sensor. However, the install was horrible, as the first screw to the motor controller loosened almost to easy, but second one. Jeez.. I was very careful for ten minutes, and then the screw was done for. So I put the torque cable aside and pushed the cables through so I...

Hm, that's something like $0.025 á km and maybe 5h? of fixing, worst case? ---------------- Question: Is the lights supposed to stay on when the battery is connected, (motor off)? My backlight is always on, I had the front connected for a while, however the tsdz2 could not sustain it.

Do have a look at the Hardware temperature control tsdz2-thread, as the various ways people mitigate heat from core to the surrounding casing helps immensely in regards of negating overheating.

Yeah, I thought it would be nice to have the original wiring as-is-intact for diagnostic purposes. Do however note that bafang has a different pinout, if you are going to have one of those. Non the less it's a good foundation, so one either make an adapter cable for a bafang displays or adapt...

Yerp, or like tomtom50 describes here, this is the cable you need: HIGO-Z812-B.

Yes, indeed interesting! Been out with the rake this morn on the interwebs, however my searchfoo maybe isn't as strong it used to be, I could only find the already mentioned fleabay-source.

My money would be on the sprag clutch. You got some milage on it, so hopefully some grease could help quite a bit, but probably not the whole way. yEOUbnMAnog

Red: 197mm Smooth Green: 10mm Smooth Blue: 20mm M12 thread Like this?