Recent content by Narcoleptic

Thanks, I'll check it out! :)

Looks solid. Thank you! :)

Thanks! I have not felt competent to do so, but since I'm now considering replacing the full motor I think I may as well give it a shot, an dif nothing else learn something in the process. Unfortunately this thread is getting pretty unwieldy as a knowledge-base, so if there is any other, more...

Does anyone know where to buy a replacement torque sensor (and other parts) in the EU? PSW only ship them from China so would be great to be able to cut delivery time some. Planning to try to get my old TSDZ2 to hang in there for a bit longer before deciding to upgrade to TSDZ8 or DMO-2...

Ok, so what's up with PSW-POWERS TSDZ8s? Other vendors seem to sell the 48V/750W version for about €500, but theirs go for €285. Is this because of the cable problem mentioned on their page or what? Since it looks like I need to cut the cable and connect my old TSDZ2-plug anyways, to fit it...

Hi guys, after giving up on fixing my TSDZ2 - that served me well for 4+ years, I'm looking to replace it. I have been using the old 36v MOTOR with a 48V controller and VLCD 5, no brakes, no throttle. The bike have a Shimano hub gear, no coaster brake. The first thing that comes to mind is a...

Hi! Pic was only to illustrate distance. Adjusting does not help. Also see my reply to pxl666 above. I remember accessing the menu fine before, but was quite awhile since I tried, so something must have happened. Use have not changed and temps have not been extreme around here, so overheating...

Hi! If you are replying to me: - Magnet has never been farther away. - Still speedometer have mostly worked good enough for years. - When speed on display have been "0.00" before this, it has NOT caused the problems described in my initial post. Conclusion: Speedometer is unlikely to be the...

Ok, tried to do as instructed but ran into trouble: My EN manual has the instruction to hold Power+I for 3 seconds followed by 4 quick presses of I. My CH/EN manual says hold Power+I for 10 seconds. No amount of holding Power+I @/after start-up screen/from power off opened hidden settings...

Thank you for that robust advice! Will explore! :)

Hi all! Early 2019 I got help by someone, who is no longer available to assist, to mount a 36V/350W kit from PSW, without foot brake + VLCD-5 350W (handlebar) controller. This person advised - and helped - me to replace the controller (in the motor) with a 48V(6-pin) version and combine it...

@ImpulsePurchase: Thanks but I doubt a cover will be a good solution because a) in rain/snow the bike will already be wet when parked outside after riding it and b) since problem arises at high humidity without rain/snow and a cover will not protect against humid air. Best possible water...

Hi all! I have some problems when starting the motor after leaving the bike outdoors now in the winter when cold and wet. Bike is usually stored indoors nice and cozy and mostly start up at first try in this case. After parking outside in humid - not even rainy - conditions, maybe just for 15...

My motor is 6-pin version unfortunately. Seems like the ones linked to in post above yours will work, and i will be shopping at PSW soon, but thanks for the link! :)

Thx man! Just to check, my brakes are not hydraulic, i just have the integrated gear-shift/brake handle for the Nexus-8. Will this still work? And did i get the main point of using the sensors right - that just resting on the pedals will not stop motor, hence brake sensors will result in more...