Recent content by NicoFr

Hello Yes they match. the electrical colored flat ribbon is only a "hack" to connect male/male connector of the throttle and controller.

Re The old attached file was too eavy..

Hello I am finally back. I try to identify the pb with your advice : I have checked the phase motor : they are not broken few mOhms between each of them. the circuit is open betwen phases and the "case" now i still have the following behaviour : (1) When i switch on the display : throttle...

Hello I would like to thank you for your help. I am in vacation until the beginning of august. I will try to repair the motor again ;) have a great summer. Thanks Nicolas

Hello Sorry to reply so late. Unfortunately i can't open the motor to check the cabling. Anyway the motor seems to turn in the proper way but as soon as i power the lcd the wheel turn and the Throttle is not functionnal msg error 8 appears I apply your procedure (ID unplugged , etc ...) Nicolas

Hello Thanks for the reply and help. -> I 've connected : the phase motor, the ID cable the throttle (i connect the 2 male / male connectors - red-white-black) The other connectors are left open (brake, motor hall sensor, PAS, ...) -> now when i swich on the lcd : the wheel start turning i...

Dear all I need some help to repair my ebike. Pb : my last controler died after a rainy day :( So i decided to replace it with a brainpower controler kslzv83 and a s866 display + handgrip (instead of PAS). My ebike is equiped with a brushless, sensorless motor - 250W / 36V I 've plugged all...