Recent content by orcasmarx@yahoo.com

Iwhenever I hook up my throttle in pass through mode to the CAv3 full throttle only goes to 1.5v. When I hook the throttle directly to the controller I get normal voltages (.86v in 3.76out). I have been talking to Justin at Grin Tech directly but I was wondering if the members could be having...

I tested a Luna 1000w brushless hub motor and a Infineon 9 fet controller. All the colors of the phase and hall sensors matched, color for color.

Thanks amberwolf for the response. I read in a thread in this forum that it is safer (for the motor & controller) to feed it just enough juice to be over the LVC with no load. This thing was only around $100 so I thought what the hell. The person who wrote the article also used one. And reason...

I have purchased a DC Power supply to test the phase and hall sensor wires for a Infineon controller and a 1000w rear hub motor purchased from Luna. I read that while testing you only use 2 to 3 amps. This DC POWERsupply is 0-60v and 0-3A. I know the voltage is good but I also read that while...

Where did you purchase the white battery insulators? I found some on AliExpress but nowhere else. James

I am pretty new to the vast expanse of e bikes. I have a cheap 300w 24v Chinese Ebike assembled by a US company. When it developed problems I called them up and they sent me the wire designations (color code) of the wires coming from the motor and a short description on what I would get for...