Recent content by oseloth

I opened them both and connected all correct wires. red to red, gnd to gnd, tx and rx to tx rx, and the last cable is probably throttle. But it didn't turn on. That was just a test. When I pluged the old one it did turned on so nothing is fried in this attempt. hehe. My life is full of strange...

For the hall side I am now 100% sure. I just changed them on the board so cabling is the same. orientation is the same. The all look in same direction towards magnets. They have slots cuted so you just can't turn them 180. I double checked any shorts to casing. None also. Bumer. I'll just...

I listened to several tracks. Quite good. I like that style of music. I'll continue tomorrow. Update on the wheel. I doubled checked all the halls. They work properly. I get 4.8V on output and 0 when magnet cross. The testing device is also showing good on off sequence. And again still the...

I always test it disconnected not to do any live shorts while probing. I am more and more suspicious about that new installed hall. I'll go first check it's polarization activation. It might be it' on in reverse. Damn that's bad to hear. You are in USA, some herbal remedies are legal there now...

I was just reading this article Testing Hall sensors And I will also test this. Who knows if the polarization of the newly installed hall is correct at all.

Ok. And that 0 Ohm resistance between plus and all fazes? They are the same but 0 when black probe is on the + and red on the fazes. But as you said the are all the same. I'll write you later afternoon. it's 8.30 AM here :) Thanks again

Ok I will test the voltages. I haven't tested them connected to controller just via ebike test box and multimeter. But I was in diode mode just checking for beeps. I will do the voltages after work. They all head a pre-carved slots and they were all facing written side out towards magnets so I...

Yes this was my thought at first, the gate problem. But I feel no heat anywhere.

Here are the measurements. Black or red probe on - and between all fazes 9.8k Between all fazes 18k But: Red probe on + and between all fazes OL Black probe on + and all fazes 0 Ohm Yes it worked properly before and than one of the Halls died. The middle one on a blue wire. I replaced that...

I'll go measure again but I think it was around 50k

No regen option on this. Only breaks that disconnect their dedicated connectors, but for sure no regen. Regen is hardly efficient on a bike. Even in cars it up to 3% of total charge. So I didn't installed one with that option. Guess I'll just have to buy a new one and test it. It look to me like...

Hi all, So I have a problem and I believe it's controller fault. When I connect controller to battery my wheel show resistance in turning. Like one faze is active. I measured GND to fazes and + to fazes of the controller and I get around 10k ohm Ground to fazes. Display is not even turned on...