Recent content by pankaj_india

the project started again.now batteries are puffed so we need to get new one. please suggest one out of this as i need to get them locally. http://www.thehobbyshop.in/index.php?main_page=index&cPath=1_67

Is changing FETs on esc with higher rating fets is a feasible option i am planning to try that on my esc. :shock:

that was hell lot of information man ..thanks :)

hey adrian(i hope it's your real name :) ) thanks for your reply . what do you have to say about my ESC because almost every member recommends CC esc's(just because they are best) ,i have done everything improvable on my cheapo ESC (added heatsink ,low esr caps,short wires to battery ,fan...

the motor i am using can take max 70amps ,the esc can deliver max 80 amps ,battery can deliver 53amps continuous and 80 amps burst.i am not going to run these things at full load all the time,moreover i have done gearing to a limit so that components don't smell bad :mrgreen: . you are right...

I am making a trike using similar turnigy 50-65d 270kv motor http://endless-sphere.com/forums/viewtopic.php?f=28&t=24572 .just wanted to know the performance of motor 1)maximum loaded current 2)maximum efficiency current 3)loaded rpm (no load will be approx 6750 @ 25v ) 4)power output 5)any...

why did he deleted the first post :?: . jeremy sir corrected him wherever necessary so he could have posted the new versions of first post rectifying the blunders. :o

Swiss post takes a fortune to deliver Batteries and whenever batteries are included they send it through swiss post .most people complaint about the mishandeling too :cry: .hoping my batteries are not dead on arrival.

Ok then that problem is solved .... :mrgreen: :D

fwd is 1st choice for me too but it seems hard to mount everything on the U-fork . :(

i am gonna use 6s 2650mah zippy lipo.yes i know range will not be much but i can increase cells in parallel anytime. and the weight is total weight with rider. for throttle control i will be using simple servo tester from HK (6$) using a clutch wire. Finished installing the heatsink (i tried...

making a trike with (5.5*4)22 gear ratio with wheel dia .5m .calculated speed is 20kmph :) TOTAL weight will be approx 80kg 8) components. 1)270kv 50-66D turnigy motor (yellow one). :) 2)hobbyking 70-80a esc (no CC :oops: ) changed the heat sink of ESC with PC processor heat sink with...

do we need controller for hub motors....or we just need to add powersuplly and control...??? i m very much new to ev conversion.......

is the hobbyking 90-100a esc is of any good.... was it the infinion or hobbyking that burned it's one FET

i also intend to convert my two wheelie ,have placed an order at hobbycity... 1)being a noob i don't want to add hall sensors and all,just esc and motor .....castle creations was very costly :( so i ordered turnigy... 2)are DEEP CYCLE LEAD ACID BATTERIES good enough for the task . 3)any other...