Recent content by PrashanBhatta

Thanks for your suggestions. I had major problem with the hall shift angle on page 3. Now the motor is working fine and smooth. But I still don't understand how the ports are mapped in page 'port setting'. I figured out that the PA0 is the pin 5 of hall connector. as shown in figure. could you...

I am using QS3000 mid drive motor with these specs. Magnet Height: 70mm, 40pcs, 5 pole pairs Diameter of stator: 138mm Rated Power: 3000W (peak power, pending) Rated Voltage: 72V as default Speed: 90KPH No-load rpm: 4400rpm without flux weakening, 6500RPM with flux weakening. Max Torque: approx...

My setup has a very low starting torque. It can't move without moving weird noise at the start. There is a setting for djusting initial torque but nothing changes on adjusting those values.

Thank you very much. It solved my overheating problem and the motor is running fine. yayyyyyyy!!!

Thanks chronosgarage for the firmware. I want to give a last shot by changing the temperature limits before changing the firmware.

Could you provide me this software? because in the version I m using, there is no such setting for temperature.

Thanks, this helped me a lot. At least I am now getting the temperature readings. But there still is a tick mark in the overheating checkbox. how can I set the temperature limits?

Hello, my EM150 controller shows a tick mark in overheating in the display page, and it is not starting. The controller and motor both are at normal temperatures. I am using VOTOL-EM-V3 2021 version. The manual says to adjust the temperature settings but i could not find in the software I am using.

I do not have settings to change temperature.

Did you find any solutions? cause I also have the same problem.