Recent content by rafid

I also wanted to use the 4080 but Kenny from cristalyte told me that 5 or 7 speed cassette wont fit in 135mm. this is why I went for the 3580. That was a mistake becasue after 2 sec I pass the pedaling speed and I dont use the pedals anyway so for my next bulid I plan to use single spped only...

When I built my ebike I also tried to fine information about it but I didn't find much. I built an ebike with Electra townie ,cristalyte 3580 , 48v50a cristalyte controller with apm display and 48v22.5ah li ion battery. the regen is working very well. I can't really tell how it recharge but...

I agree with you. I contacted the company that built the pack for me and the say that this is the way it should be wired. I asked them to separate the charging line from the main power line i.e. connect the charging line directly to the BMS but the say that it can't be done with the BMS they...

I don't have it with me at the moment so I cant take pictures. but it was examined by a technician that couldn't fine what is wrong about it. everything looked right inside. his conclusion is that something damaged the main chip. its a little difficult for me to understand. what is 3p or 4p...

Thanks for the replays what fuse to put there? my controller is up to 50A . should I go for 50A or more? Which resistor? what value and were exactly it should be installed. This one I don't understand at all unless you mean connecting the key switch to the controller power lock BTW the key...

Hi I already damaged 2 cristalyte controllers. when the charger led turns green which means that the battery is fully charged I turned on the key switch and something bad happen to the controller. The first time it happened I was sure that it's the charger fault since it was acting a little...