Recent content by rarebear

Hello Bob and Gary!! Congratulations !!!!!!!!!!!!! very impressive! My question: (12 cells LiFeBatt) Is the LVC realy needed when i set my programmable controller to a safety LVC (28V?) I would like to use your: "Charger Management System (CMS) as an external board/unit that would sit...

Hi! I think Fechter is right! with a locked rear wheel (brake) the current is only at 20-30 amps starting up from a dead stop after a few seconds (speed 30km/h) it reached 115 amps :mrgreen: Probably this is an fixed security establishment to protect the controller.

Hello controller specialists!! :P I have a question, but first my correspondence with steven from kelly: o.k.! now my settings are : Control Mode: change from speed to torque Accelerate speed: change to 10 now my acceleration is much better and the...

hi microbatman! thank you!! i used the wire harness (hall) from a blown crystalyte controller, and connect it to the include 14 pole round connector to keep it "service friendly"( wheel assembly) you can use any universal 5 pole connector for the hall wires. my (bike) frame is from a german...

Hi fechter! Highest setting for my KBL72101 Controller is 100V !!!!!!!!!!!!!!!!!!

thank you curious! What i think about the higher voltages: The controller will shut down if the voltage is too high and show you an error code (flashed led code 1,2), but it will not damaged the controller! For test purposes i run fully charged 20S lipos (84V) and had no problem! I would...

Fechter/Drewjet.... thank you! Google makes it possible! hihi! I have not yet tested regen, because i used mostly low capacity (RC)Lipos (I think that would be not so great...verry expensive!) After i find out the perfect voltage and capacity for the pack I will decide for lifepos and can...

Hi Folks! At first please forgive me my poor english!!! (come from Austria) ( no we have no kangaroohs :lol: ) But I will try to answer all questions. After a second failure on a Crystalyte i ordered a Kelly and I can tell you i am verry happy with it! The programming options are very...

Hi! O.K., I think i change to the Kelley Controller Thread ! ( O.T.!)

Thank you Albie!! Yes!,you are right .... Sometime i will paint the case black and maybee add a new black rim.

My baby!!!!!! Setup: X 5302 Kelly KBL 72101 10S 2P 42V 10Ah Lipo (Backpack only 2,6 kg) Speed 40mph on flat

My baby!!!!!! Setup: X 5302 Kelly KBL 72101 10S 2P 42V 10Ah Lipo (Backpack only 2,6 kg) Speed 40mph on flat