Recent content by RC_Kiwi

Thanks for the advice. Well I was fiddling with the voltmeter and suddenly it worked! Turns out it was simply a dodgey solder connection (my bad :oops: ). Right I'll put the iron to it and see if it works properly. Thanks for your help!

Hey. Thanks for that advice. I assume check the voltage across the entry/exit of the signal wire? I will check when I get some spare time. Not having much electronics experience, can I ask how you would put a 10K resistor from the signal line to ground? Thanks Tim

http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=10331 I cut the pot off then soldered a jumper from the signal input to the middle pot connection? This was as per the mod on page 3. I can take a photo with the lid off it it helps?

Here.

Yep :D It does have a BEC. I'll take a photo of the setup

Hi.' Am new to all this except the RC part. I did the Turnigy Modification but it does not appear to work. The motor does not respond to throttle input but slowly increases speed over time (i turned it off after 1min). However it works fine when plugged into a receiver etc. Using the turngiy...