Recent content by reset

Yip it's the display no longer comes to life if it's switched off during use. It's continues to work below 19v if not switched off. not sure if it does this without lcd. resistor bands from nearest board is gold,black,red,grey. grey resistor.

Did you have any thoughts on the system not restarting when under 19v, do you know if anyone has tested this with a variable power supply. The system runs fine down to 17v unless it times out and shuts itself down or if the power is switched off by the user.

Lesson Learnt... :flame: The part won't arrive until Monday, I'm not sure what advance angle stability is... I'm new to all of this and only have a few hours spare each week to look into this due to work and family commitments but I appreciate your patience. The motor runs fine the only...

Thanks for advice again, received Uart yesterday but unable to read any Data I think I might have blown uart by connecting 5v from controller. Originally connected via com 3 but now no longer shows in drop down. I've followed connection diagram connecting black yellow and green to corresponding...

so for this setting if I want to run battery to 16v it should be 18 x 3.7 = 66.6

The battery will run the motor fine but the whole system won't restart if it is shut down or if it times out and voltage falls below 19v. The display still shows battery with a 3 or 4 bars static or 1 bar on display if under load. Any clues would be appreciated.

hi all finally got a good setup running lower voltages but i'm curious what the option is above the pas setting on latest build. battery voltage c... I'm running 5s battery with setup but when system shuts down after set time it won't restart unless I recharge the battery above 75% I've tried...

Hi Geoff thanks for the info will check it out again tomorrow. I had tried adjusting this setting but not above 1.8. I'll give the higher values a try out in the morning.

has anyone had success with the PAS working in only one direction, any guidance gratefully received. thanks

this is the config, seems to work consistently now with the raised phased voltage. Also now have PAS working but it works in both pedal directions. Using this setup without LCD 3 and it works fine, do you know if the controller is constantly powered...

I think this issue might be phase current, just tried raising it again an it seems more consistant.

Hi I'm trying to understand the delay in motor starting, just wondered if anyone has encountered it? thanks

thanks again got throttle working turns out there is a 15 sec delay after flashing before throttle responds. LCD works without any info between controller and display. No joy with PAS so any further info would be much appreciated. Many thanks again

Should have some time to test this on monday will let you know how I get on. Thanks again

Yip I tested controller and it was fine, I'm away from it at the minute but will look again on Monday when I'm back in. Thanks again for help.