Recent content by ricsha

There is a rubber dust seal on the right side that sits in a groove of the bottom bracket. I have this pushed in flush against the bearing and according to the guide in the right direction. But after each ride it has pulled out of the groove and just sitting on the axle. When I spin the...

Here is where I ended up for now. I plant to at least remove a couple cables I'm not using. And probably shorten and direct solder the rest which will reduce the size of the wrap under the handlebars. Brake sensor is quick and dirty but working... Might need to cover this switch to protect...

Just neat, I'm trying to avoid leaving cable management last and ending up with this I'll look into the CA modified with Higo plugs, thanks.

Thanks found some more in this thread https://endless-sphere.com/forums/viewtopic.php?f=3&t=35844

Photos of routing wires off the handlebars that doesn't look like a mess? What to do with the dc power or programming cable?

Right, I pulled of the heat shrink and slid the contacts out of the shell. Looks a lot better now, I'll watch for washer deformation. I'm installing the grim rear torque arms on both sides. Thanks for the reply.

Motor has the washer and torque washer in the following order (no lock washers). It isn't possible to run the washer on the inside of the dropouts against the small axle shoulder. The lead is already terminated so I cant reposition them. Why are the supplied in this order? My dropouts are...

What are your plans for mounting them without the soft bag?

These are the small triangle packs right?

That clears up a lot thanks. I'm sure the geared mac is a better fit for me. There were just a few posts I read that made it sound like I'd be replacing clutches and gears unless if I did anything besides ride in a straight line :wink:

Cool so any idea what speed differences will be between the TC3065 and TC3080 with a 26" wheel and 50v? Edit: I did find this, TC3080 is 9.9 Kv TC3065 is 8.6 KV So between the two I should get a slower speed out of the 3065 right?

It looks like the TC3065 is slower but higher torque than the TC3080? I see it listed here but this page is not laid out very well.

Sure, I was trying to keep them in the plan because they seem common in a lot of builds, but I don't mind going without.

Thanks makes sense.

Hey first post, thanks for any help! Background: Light weight, speed 25 mph (with additional top end room) Occasional light off road, but mostly flat street under 10 mile range and with enough capacity for a couple trips between charges Steel hardtail frame (enormous triangle), 26" wheels, disc...