Sooo.... I just got my charger and connected it to a 19v input not thinking that 1v too much would do any damage (whoooopsie)... POOF and puff, a little bit of smoke came from the charger near the input cables. I took it apart and the solder on the "c3" resistor was vaporized on one end. I tried...
Ok, I just gave this a try without removing the POT and it almost works... My ESC doesn't have built in BEC so I need to hook that up to the servo tester as well. I can use the throttle, but ONLY if I turn the potentiometer up a little first. Do I need to remove the POT then? Or should I hook up...