Recent content by Silverexpress01

https://youtu.be/GeSvErqdmIM

Thank you for the information on the front fork. It's a fascinating setup. As for your Sempu, hook it back up to the CA3 and take a screen shot of the PAS device screen under SETUP. It should roughly show 1.52v when no load is placed on the shaft. Next, rotate the shaft and monitor the pole...

Nice setup Andrew, did you purchase the Sempu BB from Grin Tech? If not, and you purchased it from another supplier then it could well be a "1" wire unit. You'll need to change this parameter in the PAS Device setup screen. I run my Sempu at 14.5 v/nm., seems to be just the right sensitivity...

The irony is that the breakthroughs in alternative energy storage or power sources will more than likely come from the automotive industry or the Saudi's. It was all in humor...but in seriousness...it amazes me what humanity can conjure up in th span of 50 yrs. With the way things are going in...

Yes, it's fiction today, but tomorrow you can order the real thing via Amazon prime. For example, Today's version of the Tricorder - https://tinyurl.com/y9dagqfz Today's version of the Hoverboard - https://tinyurl.com/jrmhycl

Right underneath our very noses! https://tinyurl.com/ya8h5t24

Sure thing. Attached is the picture of the packaging. At this point the FTDI board is wrapped in electrical tape since I didn't have shrink tubing large enough to cover it. The stereo cable I got from an old headphone. Make sure you set the input voltage to "5v" with the toggle switch. Here is...

Ok. I just wanted to put closure on this posting of mine from a couple weeks ago. I ended up buying a new FTDI TTL-USB board from an electronics store (known as Microcenter) near my house. What I did differently was swap the TX and RX lines, and it worked! I was able to upgrade one of my CA3's...

Hello, My Sempu is outputting full voltage, and the pulse count no longer works. I'm guessing at the moment that the cable got pulled and wires broke internally. Has anyone disassembled one these? Can they be repaired?

Thank you for the assistance. I am planning on visiting the LBS that I purchased the CA3 from today. I'll see if he will exchange the cable for another. I meant newer than 3.1B13 - which by the way is working just fine for what I need. Truly enjoying the Sempu torque sensor and all the PAS...

In attempting to install newer firmware the Setup Utility produces a popup stating that it is unable to find the CA3 within the time limit of 30 seconds. I just tried the XP laptop and it did not work either.

It did not work with the Windows 10 laptop. I will try the slower Lenovo S10 Atom running XP later this afternoon.

The hardware are as follows, Windows XP Hardware: 1. Lenovo S10 Intel Atom CPU N270 @ 1.60 Ghz 1.99 GB of RAM 599 GB HD 32 bit O/S 2. Microsoft Windows XP Home Edition Version 2002 Service Pack 3 Windows 7 Hardware: 1. Hewlett-Packard IdeaPad Intel Core...

Hello, Truly enjoying my new CA3-DP. Over the weekend I installed a Sempu torque sensing BB. The CA3-DP has ver. 3.1B13 of the firmware, and it does not have Sempu listed as a PAS torque sensor. I've been attempting to connect the CA3-DP to a PC, so that I can upgrade the firmware and...

I recently purchased their (Magnum Bikes) ebike kit, and its been working as advertised. I've also contacted the company with questions and they responded everytime. The kit came with an 8Fun hub motor, and everything has high quality Higo ip66 connectors. The system I have is rated at 500w. I...