Thank you for responding. I figure if the hall sensors are getting 5v then that means the entire board is receiving about the same voltage. I will start testing the new boards with a TVS diode rated for this voltage. This information will at least give me a better starting point than just...
I have been working with a company that has reverse engineered a hall effect sensor board I sent them. I recently had them make some boards using the information they gathered from the donor board, but they can not give me the specifications of each component since they would need a full bbshd...
I had this issue when I changed the pass sensor settings when messing around with the programming. If you have a programming cable, go into the settings and make sure the pass sensor timing is not set below the default setting. If default is 10ms set it to that or higher. If set to anything...
I have a bbshd and after getting it last year, I noticed one of the threaded holes for the housing was stripped out. I had the idea of re-tapping the hole to a slightly larger diameter, but if that did not work, I wanted to get a replacement housing, preferably without the pass sensor and gears...