Recent content by Sonicburn

oh I see.. I understand there is no reason to replace the strips then , and the main problem I could experience would be the corrosion rather than loss of power. Thanks for reply

Hi everyone! Recently I built my first battery , a 10s3p with Samsung 35e , I am really happy with the results. Just yesterday I have done 18 miles without any effort :) I bought a Spot welder, and in the box was included 50 nickel strips, the ones I used to build my battery. Later on...

Dogman, I did not open the controller tbh, but is a Chinese generic controller , I guess are 63v.. Ok I think understood, there are standard BMSes 10s, 13s, 14s...and its not possible to install a BMS on a battery with more groups than the BMS its made for . But If I have got a higher BMS...

Thanks so much for the info As I can see its possible to change the LVC of a generic controller , changing 2 resistances (voltage divider) for different values, this ones send the amount of threshold voltage to the chip , programmed to cut off the power. Replacing this resistors , you can...

Hi , I recently build my first ebike  and I have done some tests. I am quite happy with the results. I have a 15a controller with a "350"w motor and  36v  , 10350maH  10s3p  battery with a 30a BMS. the cells I am using are Samsung E35 3450maH 10A I can run at 21mph (35 km/h) constant without...