Recent content by StormTD5

So thoughtful of you :D This bike has the VLCD 5, need to practice on that to :lol:

I'll stick to the stock display, have three bikes with tongsheng motors. I just have to learn how to work with the display :D I did Flash my dougters coaster bike, and Wow! The acceleration just at level 2! And at level 4 :lol: :lol: so fun!! Totally different bike Thank you all who made this...

Hardware calibration, well I'll guess I may have to do that but I'll probably have to change the display first to a more easy to work with. Which display can you recommend? I'm more a welder than soldering person but it's always fun to learn new skills 8)

I blame old eyes :lol: OK I'll try that :thumb: The good working bike was about 150 and max 260. I'll guess its little better. Have not used the calibration values yet.

Now I have made an calibration an with now weight the read was 23 and with 85kg rider the reading was 27. I'll guess that very low. I have used the readings and no change. With stock FW it works. I have noticed when I'm start the bike with not with full charge it can feel sluggish and with a...

I have to try harder to get torque sensor calibrated, thank you for your advice! :thumb:

I have tried my second bike...AND it works :lol: Just took it for a spin, it's alive!!! It's a hardware problem on my other bike, just gonna find out what it is. I'll begin to change the speed sensor, and then I don't know... Can it be the display? Both have VLCD 6 My daughter has a...

I'll give up... I don't understand what's wrong. When I try to calibrate the torque sensor it sometimes show code E03 and a few seconds after that the speedo meter jumps upp to max speed 99,9 km and a moment after that it's jumps down to 42 km and few moments after it's 0km. I have now the...

I'll check that to, it did however work with the stock firmware but just in case :wink:

I have tried diffrent mode on startup, weak assist on every mode... Ok, just flash the controller again :D Set parameters on startup, check! Calibrating the torque sensor Hope its the torque sensor that is the trouble Thanks for the support!!

I have change in basic settings Motor acceleration Wheel size Battery settings Assistansen settings Nothing at first but just for an experiment i raised Assist level eMTB mode and it did got a little better. Advanced settings No change I cant figure out how to calibrating the torque...

Hi everybody! Well I manage to flash the controller ( I am not a computer guy so that was a little challange :D ) but the motor it is more sluggish now than it was with orignal firmware... I have the VLCD6 display 36v motor and battery I have change some of the settings like: Motor acc. to 35...