Recent content by Supra

No not new, ive been using the display and motor with osf for about 4 months, no problems. Suddenly this proboem of running for 10 seconds and then no power, display is still on, but no assist. Display says assist is still on, in emtb mode. Could it be the controller?

My osf with 860c runs for 8 seconds , then no power. Reboot, another 8 secs. Checked all connectors, battery etc. Anyone know what is ghoing on?

Thanks

Maybe, but a friend had same experience , so i dont think so. I dont know much about coding, but the files looked different.

I didnt know about x4 and x6 , thanks.

About 3 years ago i bought a tsdz motor off a guy who imported a batch into Australia. Since then I've bought another 3 tsdz motors and none of them have had the same power and finesse. Ive put OSF firmware onto these motors, which has made them very good, but i still think the original motor...

Well I'm too embarrassed to say what i did wrong, but ive got it going really well now. Took it for a ride and plenty of power, with nice control for climbing over rock gardens. Very happy, thanks for the advice, and gratitude to the developers. mbrusa pm me your address and ill send you a...

No I'll give that a try, anything i can do about the low sensitivity ?

Ive calibrated the torque sensor 200-270. Yes i realize that a lot of trial and error is required, but the difference in power levels, even between casainho and emmbrusa osf is drastic, i cant believe its not an issue for other mtb riders.

I ride mtb only, single track and a lot of downhill, no commuting at all. I bought a tsdz2 motor about 3 years ago and its still on one of my mtb bikes. Fantastic motor , stock motor and vlcd5 display. Lots of power, only ever use level 2 of 4, nice control, good acceleration. Since then ive...

Maybe , but the power level is confusing, you press the + - buttons to adjust power level , but that brings up the wheel circumfurance setting. How do you progress on to power level?

Yeah same, the difference is significant. Theres a logical explanation, but no idea what it is. Id like to know if anyone has experienced a significant loss of power when changing displays, specifically from 8 pin to 6 pin displays.

I have a bike with Tongsheng tszd 68mm and vcld5 display and it flies, i only use level 1 even for hilly mtb. 8 pin connector. My wife has a 68mm tszd with a 6 pin vcld6 and it has a fraction of the power, have to use level 4 to get same power. I have another bike with a 100mm tszd with a 6 pin...