Recent content by troyoo

IIRC it wasn't reading the 5V at the throttle end, not sure about the PAS cable. It is kinda hard to check as all the plugs are Julet waterproof. Have to make some pins or a sacrificial cable to check it properly. Yes, I was testing the same exact display on both controllers (to make sure it...

42.2V IIRC, same as my fully charged battery

So I've chopped an USB cable and used a phone charger to power up the throttle alone. It works just fine, 0.87V-4.45V at full throttle. The 49.9km/h was max recorded speed by the controller, not a live readout. Checked some other stuff with a multimeter today as well. There were no shorts on...

I've checked the voltage comming out of the throttle. It shows 0.8-0.9V no matter the lever position. Checked with 2 different throttles. FWIK it should read closer to 4-5V at full throttle, am I right? Or as controller sees the battery as empty, it doesn't allow to voltage to go higher in the...

I've just ordered a multimeter to check the voltages, although all connectors are Julet waterproof, so it might be a challange, but will try that! I don't think LCD4 has L settings, although C12 parameter seems simmilar to what You are refering to? Is that correct? "C12 Controller Minimum...

When I connected both displays for the 1st time it has shown the battery with full capacity. Only when I pressed the throttle, enerything went wrong. LCD4 no longer sees any battery as full. Maybe the controller fries it once it gets to send full power to the motor? I've ordered a different...

Hi folks! I've bought a KT 36V tubullar controller (julet plugs) kit with LCD4 display and PAS sensor. Paired it with AKM 250W 100 CST hub motor and Wuxing 108-2 thumb throttle. Thing is, when I had connected it for the 1st time, it run for few seconds, and then stopped reacting to throttle...