Recent content by Tuomito

This problems was solved, a bad solder in one of the xt90 series connectors

Thanks for the answers.. I already have the "Pedalec Positive Motoring Torque Ramp (ms)" set to 50ms.. I try today change the "Pedalec sensorless open loop frequency ramp time" from 300ms to 100ms and see if that helps. I different problem with the setup is that I have been getting some...

Hello I Have been running the cyc x1 Gen2 for a some time now, about 400km. Mostly commuting to work but also winter trail riding here in Finland. After changing some of the settings I am now pretty pleased with have the motor works. I ride using pas, torgue sensing. I use the thumb throttle...

Going to charge each 4s pack separately, if cell balance is good, I understood I´m able to charge all at once with parallel board. Very thankful for this! Thank you for quick answer!

Hello I'm building an ebike with a cyc x1 pro motor (with bac855 controller max rated power 3000w) and with a 16s lipo battery (4x4s 8000mah batteries in series, 30C rating). I'm planning to charge the batteries with my rc lipo charger, in parallel. The charger has a balance function and the...