Recent content by vjpcat

Is there any way to determine that without documentation like with my multimeter? If so, I'm not sure how to go about it.

Hi y'all. So, the connectors still work great, but the battery has since deteriorated at an accelerated pace. I'd like to replace the three SLA battery pack with something lighter, possibly LiFePo4, though it may be too expensive for me, regardless, I'm not sure what my controller is rated for...

i did it! it works! and i hooked the batteries back up to the controller and tested the throttle and it all works fine. i can not thank you enough - y'all made it super easy for me from troubleshooting to diagnosis and repair. great advice all around - i am ever so grateful :D i went with...

yea thx dogman. i'd like to solder it, but i'm new to soldering too and not so confident i could make a clean enough joint, so i'm going to crimp. i was going to say i hadn't read anything yet that recommended one way over the other, until just now when my friend showed me a how to article on...

ok, i checked the batteries and they're good - 38.99v. the wires inside the bag looked ok, but should probably be cut and reconnected with more heat shrink as i did see some copper. oh yea, my charger is not even 2 amp. it is only 1 amp, which i guess just means it charges slower? or maybe...

hi y'all - ok, let me run thru your replies again - quickly tho. dogman - i will follow your suggestions and i will get the anderson power poles. i have already replaced the controller connectors once before, as well as the motor ones which are the same - pigtail trailer hitch style - they...

thanks for all your responses - i will read thru them in a bit. i just wanted to let you know that i've updated my original post with some pictures - hope they help. also, the batteries used here are SLA. el_walto - yes, i do have a dmm, but i'm afraid to touch anything on the bike right now...

thank you. i'm not sure i completely understand that - there is only one connector (an RCA style plug), and i think it does have two wires coming out of it, but i will post pix soon - i figured it would be helpful. also wondering if i posted this question in the most appropriate section of this...

hi everyone - i'm new here and don't know a whole lot about ebikes, but i've got a serious problem with my set-up and don't know what to do or if the system is fried now or what. here's a little background on my bike: a friend gave me her bike which had an aotema front hub installed powered...