Recent content by wheex

I tested 15.1 on my daily commute, and I discovered some power related issue. I've got the 48V motor and I use 48V battery, everything default: max current 16A I set max power 850W and in assist level 2,3,4,5 when the human power goes over 350-400W the motor power limited around 500-550W and...

Here is my data tabs after a successful fresh install and my LCD didn't worked. https://drive.google.com/open?id=1AT4z0apFW0vR-A27zt45bxTGIj9_pJlR. I experience random fault after a fresh install sometimes the display works sometimes not when I use the same hex files and method, if the display...

OK I will post it when I got home in the evening.

Do you think I have problem with TX/RX pins even in that case when the LCD3 is working after a fresh install, it shows the speed correctly, I have assist too. But after I turn off the lcd it's no longer start again.

I think my motor controller's EEPROM on address 0 is faulty , the symptom is when I turn on the LCD it's isn't start up, stuck at initialization only showing all symbols (this occured for me yesterday firstly on the ride from work to home and I didn't flash my controller a while so it's not...

I'am using Busch + Müller IQ-X E bought from here https://www.rosebikes.com/b-m-lumotec-iq-x-e-150-lux-e-bike-headlight-2658822 I'am using an Omron G5V-2-H1 6VDC relay to switch it. I'am put the relay inside the motor housing and connected directly to the battery so only one extra wire goes out...

Yesterday a tested the 0.12 version and my lights working, I can switch it off and on. The motor assist is working when my lights is on.

Sorry I don't have oscilloscope, but I measured with multi-meter and when the backlight is on on the LCD it's 6V on the green wire and 0V when it's off. I marked the connection on the controller. PSWpower sell lights for tsdz2 Front Rear but I 'am using this wired directly to the battery and...

Can somebody please upload the original improved firmware for kt-lcd3 and for tsdz2 48V version, it's removed from GitHub, and I want to give it a try because the light control is working in it.

Hi, I tried the new opensource firmware the 0.5 version, and it's awesome much more efficient, stronger and the cadence is around 90-95 rpm with a 48V motor and battery, and stock settings. Thanks casainho to made this, with the new firmware it's feel like I have a new motor. Can you help me...

The DS18B20 is a cheap reliable temp sensor. I think there are some kind of temp sensing built in the controller because when I used my bike in the winter under -10C an error show up in the display.

Tomorrow I can take photos from a 48V controller, I 'm struggling to open the unit because I ruined the four screws head that hold the case.