Recent content by wizardchess

As of a day ago, I've run into an inexplicable issue where the watt limit is active even though the CA shows the motor watts are far below the limit I have set (1500W). Trying to engage the motor via PAS never gets the motor above 300W, even with the PAS level maxed. Prior to this happening, I...

This ended up being the solution. I already had an OTG cable, just had to pull out the baserunner and run the TRRS cable through the frame into it, then put it all back together. Sure enough, it was overheating. Threw on a custom heat sink and it isn't a problem anymore.

I explained in another post that the baserunner isn't accessible and can't be monitored. It takes roughly 5 - 10 minutes of disassembly just to get access to it.

52V. Z9, but I'll be upgrading it to the L10 in the future.

Not sure. The baserunner is kept in a hollow channel in the downtube designed for the controller to and not easily accessible. I would have to disconnect the battery and remove several small machine screws to take off a cover to get access to it. In any case, I had to take the metal cover off as...

I'm trying to troubleshoot an inconsistent issue where I can't get much more than 500W going into the motor after riding for several miles. Phase amps is set to 50A on the baserunner, CA battery current is set to 25A and watt limit is set to 1500W. I can reliably pull around 1300W before the amp...

This is my first build, so I expect I've configured something incorrectly, though I haven't figured out what yet. In short, I have a CA3 connected to a baserunner connected to a Bafang G60. When the wheel is on the ground/under load, the speed is incorrectly detected as being over 100 - 300MPH...