Recent content by wldmki

I’ve just downloaded the zip from github, failed compilation for the Wiiceiver_2_0 I also had compile problems as mentioned earlier, added '#include <Arduino.h>' into Wiiceiver_2_0.ino and rename 'tuna.h' to 'Tuna.h' also failed on every line that contains EEPROM.update(... changed all of them...

Yes, machined up the adaptor. The shaft is drilled and tapped so a standard pocket bike pinion screws in, and the collar is over the top. I have been working on the throttle profile, now it has smoother control rather than popping mono's and throwing me. Also bought a narrower motor since this...

Thanks Thud, some more progress this week: This is the motor mount, had a lot of flex so added the angle down the side.. Cut out pockets for batteries taped up and ready to go, could not resist taking it for a spin.. :wink: The yellow board in the middle is custom throttlizer I'm...

Peeled off one half of the box, foam filled nicely but still a little soft heres some more pics: Foam still wet and it expanded a little more than expected decided to buy some new brakes for front and back Close up of pocket bike pinion mounted to motor shaft. the pinion screws into the...

Hi all, first post here. Here's a few pics of a BMX I've started working on. A few years ago I had it running a 49cc pocket bike engine. It was a fun bike, could reach 52Km/h, very loud and smelly. It was a filthy high maintenance ride. Last year began converting a MTB to run a c80-100...