Search results

Date Relevance Most replies

  1. S

    Cycle Analyst - Solar Shunt Parameter

    I have my setup working great for the past 3 summer but this year, I had an electrical problem and my solar reading was all wrong, -1400 instead of the regular +300 Watts and it was very unstable. I repair the original electrical problem, but reading was still wrong, so I decide to buy another...
  2. S

    Fuse selection for custom eBike

    I'm no electrician :-) I have two motor attach to two 52 volt battery on my solar eBike. With both motor at maximum, I see around 2400 watts going out the battery. I found some fuse rated 40A at 58 Volt but so far I melted 2 of those, when I go at full speed for a while. Do you have advice...
  3. S

    eBike 2 motor with one regenerative

    I have two motor, a Bafang and an Ezee. I am looking to the the Ezee for this one with regenerative capacity https://www.ebikes.ca/product-info/gmac.html From what I understand, this emac motor could be my main way of breaking in my city ride. I switch between motor regularly during a ride...
  4. S

    Max Amp and Watts on 12 gages 4 feet

    I have two 52 Volts battery and 2 motors. if I used both motor at maximum capacity I consume about 2200 watts I was using 10 gages cabling but I had problem with my Anderson connector because the cable were too big to fit in the connector. I want to switch to 12 gage. I will have about 4-5...
  5. S

    Bafang eBrake problem and maybe Cycle Analyst

    I have 2 motors on my bike A Bafang with it's own controller and an Ezee with a Cycle Analyst. My problem is related to eBike signal. On the Bafang. I have a lot of difficulty to find a position to place the magnet in a way that it will get further from the detector when I press the Brake...
  6. S

    Cycle Analyst with 2 shunt with new firmware

    I would really appreciate any help with my problem with Cycle Analyst (CA) V3 CA-DPS and shunts. I have a solar eBike. I have two motor with each their own controller and throttle. I have bought two Shunt 1- The standard one - http://www.ebikes.ca/shunt-ca3.html will be used to...
  7. S

    Cycle Analyst and Battery Charge Cycle

    When I configure Cycle Analyst (CA), I have to specify everything about my battery in a way that CA know the Wh capacity of my Battery, Then, when I use it, the CA can give me how much Wh I have consume. Which is great Then why do CA need me to Reset it each time I put in a Fully Charged...
  8. S

    Ezee motor and 10K NTC thermsitor

    I bought an Ezee motor 350 RPM and I will travelling in mountain for a few weeks. I am afraid of the temperature of the motor combine with the fact that air pressure at those altitude is below 70 kPa, the cooling won't be optimum. I dont think my Ezee motor has a temperature sensor build in. I...
  9. S

    Cycle Analyst - Battery config problem

    I bought this battery from Grin Tech http://www.ebikes.ca/shop/electric-bicycle-parts/batteries/b5216-lim-dt.html which is rated as 52V 16.5 Ah When I received the battery, there was a sticker on it, written by hand sting 17.5 Ah. Great :-) I setup my Cycle Analyst (V3) CA at 14 cells from...
Back
Top