Search results

Date Relevance Most replies

  1. KaiKall

    Custom Battery Cyclone 3000 Downhill Bike

    Thanks, Bike is 80lb and i am about 200. The rear shock is a roco, came with the bike when i bought it. I had to dial the pre-load up quite a bit as the suspension is super soft when setup for downhill. I want to make some fenders out of sheet metal and weld it to a custom rack as one piece...
  2. KaiKall

    Custom Battery Cyclone 3000 Downhill Bike

    This has been in the works for quite a while now. I still have a bunch to do but the bike is finally in working order. This is the first big ride i have done so far, went 65km using just over 1100Wh, the bike is much easier to pedal than i expected. Specs: 2008 Kona Stinky Downhill Bike Frame...
  3. KaiKall

    Kelly Programming Cable

    I have a KBS72121X controller I got with the Cyclone 3000 kit from Luna. I want to program the controller but the 3rd party cable I ordered on amazon didn't work. The cable direct from Kelly comes to over $60 after shipping to Canada. Does anyone know of a cable that has worked for them so I...
  4. KaiKall

    Kelly KBS72121X Low Hall Voltage

    I tested the current going to the halls and it is 10mA if fed by the controller, although i still get the fault code. It measured 15mA if i used the 12v circuit to power the halls, and the motor does work, although it does not seem to reach max speed.
  5. KaiKall

    Kelly KBS72121X Low Hall Voltage

    The 5v made it run quite rough, but i also tried using the supply from the 12v system i have using a dc-dc converter. The motor seemed to run well using this. Is it fine to use the dc-dc for the hall power? Thanks Kai
  6. KaiKall

    Kelly KBS72121X Low Hall Voltage

    Using the 5v supply from the throttle stops the hall error i had, and the motor was able to spin for a few seconds, though it seemed to run rough. After i let go of the throttle it would no longer spin, but there was still no error code. The voltage stayed at 5v the whole time.
  7. KaiKall

    Kelly KBS72121X Low Hall Voltage

    I tested the supply line for the halls and i could not get it to register any current passing through. What is weird is that the all good green light is on the controller until the throttle is pressed. Thanks
  8. KaiKall

    Kelly KBS72121X Low Hall Voltage

    The motor and controller came as a kit from Luna, and I have been using the same connector for all the testing, and it was working earlier. How would i go about testing the hall sensors? So far i have measured the resistance and it appears that nothing is shorted. The halls are alternating...
  9. KaiKall

    Kelly KBS72121X Low Hall Voltage

    After looking through some more info here i found that the controller is outputting 12v across the hall sensor +/- when the halls are not plugged in(the phase wires still are). When the halls are in the voltage drops to ~2.15v, with the halls alternating between 0-3v. The voltage across the...
  10. KaiKall

    Kelly KBS72121X Low Hall Voltage

    I am building my first bike using a cyclone 3000 and kelly controller as bundled from Luna Cycle. I am just at the point of assembling everything. With the bike upside-down motor was able to turn, and ran well earlier today before installing the throttle on the bike (same throttle and pins)...
Back
Top