Search results

Date Relevance Most replies

  1. C

    Total headless mode for BaseRunner? (No display, POS sensor or torque sensor)

    I did my victory dance a little too early. I'm not able to get a proper output from the throttle. It still maxes out around 1.2 to 1.3 V; which is barely a 2-5° twist and the motor reaches the maximum speed. Just a slight touch and the motor starts softly, until I twist a bit more and it shoots...
  2. C

    Total headless mode for BaseRunner? (No display, POS sensor or torque sensor)

    There you go!! That did it. I shorted the Blue ebrake to the throttle Green signal and I have a functional throttle. Motor spins up slowly and gradually but achieves the max speed at only 1.3V of throttle signal(by twisting the throttle ever so slightly); so I need to adjust parameters in the...
  3. C

    Total headless mode for BaseRunner? (No display, POS sensor or torque sensor)

    So I finally have results after measuring with a multimeter. When I connect only the throttle; my voltmeter reads ~0.85V between the Signal and Ground. It reads ~4.7V between ground and +ve. When I move the throttle; the signal and ground starts going up from 0.8V to ~4.5-4.7V; which I believe...
  4. C

    Total headless mode for BaseRunner? (No display, POS sensor or torque sensor)

    Thanks for the input; I might have to try with a multimeter afterall. About the controller being fried; I don't believe that happened because the motor still spins upon engaging brakes(while ebrake pin is connected as per the diagram) and I could run all the tests with the phaserunner suite...
  5. C

    Total headless mode for BaseRunner? (No display, POS sensor or torque sensor)

    I'm currently running a baserunner system on my standard moped style e-bike. I'm running it in headless mode and I have made the connections as per the diagram below. The issue is that I thought that e-brake is the motor cut off that you use with your brakes; so I hooked up the e-brake as per...
  6. C

    XLD Brainpower motor controller XunLiDa

    Not sure about the regen braking, I have yet to figure that out. About the speed controls, yes. If you short all 3 - low speed; leave everything disconnected - medium speed and keep the two cable connected- max speed. Sent from my SM-G960U1 using Tapatalk
  7. C

    Voilamart bldc

    Is it for the stock controller? It's pretty much as the manual says, match the same colored wires and you are good to go. Sent from my SM-G960U1 using Tapatalk
  8. C

    Motor Vibration/rattling sound

    Luckily I was able to return both the batteries. I now have one from UPP which holds up pretty well as per the specifications and provides ample power to the motor. Motor is fine, I can easily hit ~35mph speeds and I get around 10-12 miles of range. Just that, I miss the silent(just a slight...
  9. C

    Motor Vibration/rattling sound

    Well it still makes that noise with the stock controller, the after market (XLD) controller is working fine now, atleast to the point I can ride my bike easily for daily commute. Although the sound is just stuck and my motor is no more silent. Sent from my SM-G960U1 using Tapatalk
  10. C

    Motor Vibration/rattling sound

    I bought a Voilamart 500w front kit setup and a cheap 20Ah Blue chinese battery. Since the start, motor was very quiet and just gave out a whiny sound, I can reach 24mph top speed with a decent acceleration from the blue chinese battery. Although, the range was somewhere around 6 miles max and...
  11. C

    XLD Brainpower motor controller XunLiDa

    Hi! I had the same ignition pin confusion; after connecting the orange cable to battery +ve, the motor does turn on. But as soon as I accelerate, the motor makes weird kind of vibration sounds and the wheel does spin fully but I'm not sure about this vibration. The battery wires and the motor...
  12. C

    Battery vs controller vs motor rating limitations

    https://www.ebay.com/itm/163943339328 I have this in mind. Sent from my SM-G960U1 using Tapatalk
  13. C

    Battery vs controller vs motor rating limitations

    https://www.ebay.com/itm/163943339328 What do you think about this battery? I read Lifepo4 are somewhat better. Also it's within my budget (~$200). Sent from my SM-G960U1 using Tapatalk
  14. C

    Battery vs controller vs motor rating limitations

    Makes sense, any 36v battery suggestions? Sent from my SM-G960U1 using Tapatalk
  15. C

    Battery vs controller vs motor rating limitations

    That makes sense. This clears out a lot for me. I was skeptical but still went through with this battery but Good that I can still return it. Any recommendations on a good 36V battery? Also should I be looking at constant discharge rate of battery or the max discharge? Few good Hailong...
  16. C

    Battery vs controller vs motor rating limitations

    Sure, there you go. https://www.ebay.com/itm/293314294162 Bought it for $190 with a 2 year ebay warranty on it. Sent from my SM-G960U1 using Tapatalk
  17. C

    Battery vs controller vs motor rating limitations

    So I have a few questions with my ebike build. I bought the 500w voilamart conversion kit off ebay, 36V 20Ah blue battery off ebay too. From initial tests, I'm getting a top speed of 24mph(throttle only) for first 10minutes after charge and then it drops to 20mph consistent. After 8-10miles of...
Back
Top